Inspect the Wooden Pallet Before Applying Stretch Film

Use a pre-wrap pallet inspection to find broken boards, protruding nails and contamination before they damage film or destabilise freight.

Inspect the Wooden Pallet Before Applying Stretch Film article image

Film is often blamed when it tears at the base, yet the failure may begin with a splinter, protruding nail or broken deck board. Once the load is wrapped, clear layers can make these defects harder to see and a forklift movement can turn minor damage into a failed pallet.

A short pre-wrap inspection protects the film, the load and the handling process.

Check structural condition

Confirm the pallet type and rating suit the load and handling system. Look for broken or missing boards, split blocks, loose fasteners and evidence of previous impact. Check that the pallet sits flat without rocking.

Do not ask an operator to wrap around structural damage or use film as a repair. Move the load using an approved process and replace or repair the pallet under site rules.

Inspect contact points

Run a visual check around the perimeter and base where hand stretch film will pass. Remove loose splinters only through an authorised pallet-maintenance process; isolate exposed nails, sharp staples or banding remnants.

Check whether cartons overhang or gaps leave the bottom layer unsupported. Confirm forklift entry remains clear and that no film rope will be dragged beneath a damaged board.

Look for contamination

Oil, water, powder, broken glass, chemical residue and food contamination require the relevant site response. They can change friction, reduce cling, damage product or expose workers. Wrapping contaminated material is not containment or remediation.

Record rejection reasons

Use simple defect categories and photograph recurring faults where permitted. Link defects to the pallet source, load family and receiving point. This data can distinguish random wear from a handling or supplier problem.

The NHVR advises protecting wrapping from cuts and tearing and ensuring handling equipment does not damage it beyond acceptable limits. It also stresses the pallet connection when unitising loads. See the NHVR loading guide.

Verify after the first move

After wrapping, inspect the base following the first forklift handling cycle. Look for torn film, lifted layers, contact with forks and movement between load and pallet. A passed pre-check does not excuse an impact during handling.

The approved pallet wrap pattern should begin only after the pallet is accepted. That small gate prevents operators from spending extra film on a platform that was never fit to enter the wrapping process.

Tags

Related Articles

© 2026 Cline Plus, Powered by Shopify

    • American Express
    • Apple Pay
    • Google Pay
    • Mastercard
    • PayPal
    • Shop Pay
    • Union Pay
    • Visa

    Login

    Forgot your password?

    Don't have an account yet?
    Create account