Should Stretch Film Touch Painted or Polished Products?
Assess direct contact between hand stretch film and painted, polished or coated products before marks become a customer complaint.

Clear film wrapped directly around a painted cabinet, polished metal panel or coated component can look like simple protection. In practice, pressure, heat, surface contamination and movement may leave impressions, trapped grit or transferred marks.
Ordinary pallet stretch film should not be assumed to be a surface-protection film.
Identify the finished surface
Ask the product owner what coating is present, how fully it has cured, and which packaging materials are approved for contact. Fresh paint, soft coatings, decorative laminates and high-gloss finishes may react differently.
Inspect for oil, dust and metal particles before wrapping. Film can hold contamination against the product, and transport vibration can turn a small particle into an abrasion point.
Introduce a compatible separation layer
Where direct contact is not approved, use a clean, non-abrasive interleaf, sleeve or protective sheet specified for the surface. Ensure it cannot move or create a slippery load. Corner and edge protection may also be needed so tension is distributed without marking the finish.
Run a controlled dwell and route trial before allowing hand stretch film near saleable surfaces. Check immediately after wrapping, after the expected storage period and after temperature exposure representative of transport.
Record:
- coating or finish specification;
- curing age at packing;
- separator material and orientation;
- applied wrap pattern;
- temperature and dwell time;
- rub, imprint, colour transfer or residue after removal.
Do not use a successful short trial to claim universal compatibility. Suppliers of the product finish and protective material should approve the contact system where appearance is critical.
Use pallet stretch wrap to unitise the protected load, while treating finished-surface protection as its own packaging requirement.
FAQ
Does stretch film contain glue that leaves residue?
Cling systems vary. A mark may involve additives, pressure, contamination or the product coating; investigate rather than guessing.
Is kraft paper a safe separator?
Only if testing confirms it is clean, non-abrasive and suitable for the finish and moisture conditions.
Tags
Australia
Hand Stretch Film
Pallet Wrapping