Hand Stretch Film for Tall, High-Centre-of-Gravity Pallets
A practical Australian guide to assessing tall pallets, top movement and centre of gravity before relying on extra stretch film.

A tall pallet can remain square on the warehouse floor and still behave poorly during braking, cornering or forklift travel. Movement near the top is magnified by height, while a narrow footprint or heavy upper layers raise the centre of gravity.
Adding film at shoulder height may reduce visible sway, but it cannot correct a badly ordered stack or an unsuitable pallet footprint.
Map weight, not just carton height
Record total height, pallet dimensions and the approximate weight of each layer. Place dense cartons low where product and handling requirements allow. Avoid building a light base beneath heavy top stock merely to match a pick sequence.
Check whether the load is permitted through doors, racking, conveyors and the carrier network. A stable load that exceeds an equipment or receiving height limit is still an unacceptable dispatch.
Control the top interface
Top caps, corner boards or layer sheets may help maintain geometry, but they must be compatible with the cartons and film. A loose top board can become another moving layer. Do not use extreme hand stretch film tension to pull a leaning top back over the centre.
Build containment by zone
Specify and check the base, middle and top separately. The base connection is important because the load must move with the pallet rather than slide across it. The upper zone may need additional containment, but every added revolution also increases compression on corners.
The NHVR notes that wrapping requirements depend on product weight and interlayer friction and that wrapping should include the pallet at the base where required. It warns that capacity must be known before film is relied upon in restraint calculations. See the NHVR guide.
Test handling dynamics
Any dynamic handling check must operate under an authorised site test and traffic-management plan, with a competent, authorised forklift operator and a defined exclusion zone. Do not deliberately provoke instability. Move an accepted trial pallet only through normal acceleration, turns and floor transitions at controlled operating speeds, then inspect for top sway, layer slip, film lift and pallet flex. Follow with a representative transport trial where the consequence warrants it.
Define an escalation limit
Set maximum approved height, load family and layer order for the manual pattern. State when the pallet must be rebuilt, split, mechanically wrapped or referred for load-restraint review. Operators should not improvise with extra film above the documented limit.
A tall load needs a controlled unit-load design, not a taller column of plastic. The selected manual stretch wrap should preserve a stable stack whose weight distribution and route have already been assessed.
Tags
Australia
Hand Stretch Film
Pallet Wrapping