How Much Should Hand Stretch Film Overlap on a Pallet?

A practical guide to hand stretch film overlap, effective coverage and trial checks for Australian warehouses wrapping mixed pallet loads.

How Much Should Hand Stretch Film Overlap on a Pallet? article image

“Use 50 per cent overlap” is common advice, but it is a starting point rather than a universal pallet specification. The right overlap depends on the film’s width after stretching, the load profile and the holding force required at each height.

Measure the film on the pallet

A nominal 500 mm roll will usually become narrower as it is stretched. This neck-down means an operator who moves upward by 250 mm per turn may achieve less than 50 per cent overlap in practice. Mark two carton edges or use removable tape during a trial, then measure the visible advance between successive passes.

For a routine square load, consistent overlap matters more than chasing an exact number by eye. Gaps create weak horizontal bands; excessive overlap may simply add plastic without improving the part of the load that moves.

Match overlap to the risk

Increase local coverage where the load changes shape, where cartons have low-friction coatings, or where a layer transition tends to open. Do not assume that more overlap can correct pallet overhang, damaged cartons or a poor stacking pattern.

The National Heavy Vehicle Regulator notes that the number of wrapping layers depends on goods weight and friction between product layers and the pallet. It also recommends following the manufacturer’s instructions and verifying performance where wrapping contributes to load restraint.

Run a repeatable trial

Compare the current hand stretch film and proposed pattern on the same load family. Record:

  • stretched film width on a flat face;
  • upward advance per circuit;
  • extra passes at the base and vulnerable layers;
  • film weight used per pallet;
  • movement or damage after the normal route.

Write the result as an observable instruction, such as “advance by half the stretched web width”, rather than “overlap well”. A short marked-up photograph at the wrapping station is often clearer than a percentage alone.

If operators cannot reproduce the pattern, revisit roll width, dispenser control and work pace before adding turns. Select pallet wrapping film by tested load performance, not overlap folklore.

FAQ

Is 50 per cent overlap always enough?

No. It is a useful trial setting, but the load, film and transport task determine the required pattern.

Should every part of the pallet receive the same overlap?

Not necessarily. Base connection and unstable layer transitions may need additional coverage.

Tags

Related Articles

© 2026 Cline Plus, Powered by Shopify

    • American Express
    • Apple Pay
    • Google Pay
    • Mastercard
    • PayPal
    • Shop Pay
    • Union Pay
    • Visa

    Login

    Forgot your password?

    Don't have an account yet?
    Create account