How to Keep the Top Pallet Layer from Moving
Diagnose loose top cartons on a stretch-wrapped pallet using stack geometry, corner capture and a tested wrap pattern—not extra film alone.

The lower half of a pallet can feel solid while the top cartons slide or open during handling. This usually means the upper layer is not properly integrated with the rest of the load, or the stack geometry gives the film little to hold.
Check the top layer before wrapping
Confirm cartons are closed, square and supported by the layer below. A small top tier sitting in the centre of a larger layer creates shoulders that a horizontal band may miss. Overhang and large gaps should be corrected at the pallet-building stage.
If cartons are crush-sensitive, do not pull harder until their corners deform. A top frame, corner boards or revised layer pattern may distribute force, but each addition needs testing.
Observe where the film travels
During the trial, watch whether the web captures the upper corners or slides beneath them. Diagonal passes can help integrate some profiles, but they can also apply concentrated downward force or cover labels. Use the film supplier’s method and the approved load standard rather than improvising.
For hand stretch film, record:
- top-layer footprint relative to the layer below;
- applied web width and overlap;
- number and position of upper passes;
- carton deflection immediately and after dwell;
- movement after the representative route;
- film weight used for the complete pallet.
The National Heavy Vehicle Regulator advises that wrapping layers depend on goods weight and friction, and that heavy or sharp-edged loads may need additional restraint. A stable-looking top layer does not replace the vehicle restraint assessment.
Make the check repeatable
Photograph the accepted top pattern from two sides. At dispatch, reject pallets with loose corners, film riding down or a top tier that has shifted from its reference position.
Choose pallet wrapping film by delivered top-layer condition, not by how tight the film feels at the base.
FAQ
Should film go over the top surface?
Only if the approved pattern and product allow it. Covering the top may affect ventilation, access or carton compression.
Will more top wraps always help?
No. Extra film cannot correct an unsupported or badly positioned top tier.
Tags
Australia
Hand Stretch Film
Pallet Wrapping