Hand Stretch Film for Bricks, Tiles and Building Products
A practical Australian guide to unitising rigid building products without relying on stretch film alone for heavy or sharp-edged loads.

Bricks, tiles, pavers and boxed hardware combine high mass with rigid edges. The products may be stable when tightly stacked, yet a chipped corner, broken pallet board or small layer shift can cut film and release individual items.
For these loads, wrapping is often useful for unitisation and surface containment. It should not be treated as the only transport restraint unless capacity and performance have been established.
Inspect product and pallet condition
Remove loose fragments and isolate broken packs. Check pallet rating, deck-board condition, nail heads and the fit between product footprint and pallet. A heavy pack on a weak pallet cannot be repaired by wrapping the outside.
Keep products supported and avoid overhang. Where the supplier pack includes trays, bands or corner protection, confirm their condition before adding film.
Prevent puncture at the source
Use suitable edge or corner protection where sharp rigid contacts meet the film. The protector must remain in position and spread force without becoming another hard projection. Dust and grit trapped beneath film can also abrade the surface during vibration.
Select hand stretch film only after assessing puncture risk and the operator’s ability to apply it consistently. More thickness is not a substitute for removing an exposed sharp point.
Combine restraints deliberately
Strapping, caps, edge protection and film may work together, but each needs an assigned role and application sequence. Protect the film from strap edges and avoid applying concentrated force to fragile tile or paver corners.
The NHVR case material shows how sharp rigid brick edges can damage wrapping and allow product to escape. Its guidance warns that heavy loads and penetrative edges should not rely on wrapping alone. See the NHVR stretch and shrink wrapping guide.
Verify the full route
Inspect after forklift entry, warehouse travel and loading. Run an appropriate transport trial and check for film ride-up, abrasion, loose fragments, strap movement and pallet damage. The vehicle restraint system must still meet the applicable requirements.
Write load-specific limits
Name the product format, pallet, film, protection, other restraints and maximum approved pack condition. Include rejection criteria for broken units, wet cartons or damaged pallets.
A controlled manual stretch wrap specification helps contain a suitable building-product pack. It does not turn loose masonry or an unverified heavy load into compliant freight.
Tags
Australia
Hand Stretch Film
Pallet Wrapping