Anti-Slip Sheets and Hand Stretch Film: Test Them Together
Learn how interlayer friction, anti-slip sheets and hand stretch film work together when stabilising Australian pallet loads.

When carton or bag layers slide, adding more film increases inward pressure but does not necessarily improve the interface between products. An anti-slip sheet can change that interface, yet the result depends on its coating, placement, load and storage conditions.
Treat the sheet and film as one tested system rather than two independent upgrades.
Find the moving interface
Mark a trial pallet and identify where displacement begins: product against product, carton against tier sheet, or bottom layer against pallet. Adding anti-slip material at the wrong level can increase cost without addressing the actual slip plane.
Check for dust, powder, condensation or damaged packaging that changes friction. Correct the contamination source before approving a consumable solution.
Select a sheet for the product
Confirm dimensions, coating, moisture response, compression behaviour and any food-contact requirement. The sheet should remain flat and supported within the load footprint. Oversized corners can fold into the film; undersized sheets may leave outer cartons unsupported.
Rebalance the wrap pattern
Higher interlayer friction may reduce movement, but it does not remove the need for containment or a pallet-to-load connection. Apply the proposed hand stretch film using a documented pattern and measure the completed load at consistent points.
Do not automatically keep the old number of revolutions after adding anti-slip sheets. Trial whether the combined system can meet performance with less film, the same film or a different pressure distribution.
The NHVR specifically notes that low friction between rows can cause excessive movement and that anti-slip material may help. It also says wrapping requirements depend on weight and friction and that film capacity should be known. See the NHVR wrapping guidance.
Test realistic conditions
Include the humidity, temperature and dwell time expected in storage. Run forklift handling and a representative transport route. Inspect sheet movement, carton scuffing, load lean, film breaks and the condition of the bottom layer.
Control substitutions
Record the approved sheet grade, film, load family and wrap pattern. A plain paper divider is not automatically equivalent to a coated anti-slip sheet, and a new film may apply different compression to the same interface.
The useful outcome is not “more grip”; it is a repeatable pallet using a defined pallet wrap and interlayer material. Procurement should change either component only through a controlled trial.
Tags
Australia
Hand Stretch Film
Pallet Wrapping