Paper Void Fill for ESD-Sensitive Electronics

Understand where paper void fill fits around ESD-sensitive electronics and why an approved electrostatic protective package must come first.

Paper Void Fill for ESD-Sensitive Electronics article image

An electronic component can arrive without a dent and still be damaged by electrostatic discharge. That makes ESD-sensitive products fundamentally different from ordinary boxed goods: controlling movement is necessary, but it is not proof of electrical protection.

Standard paper void fill should not be described as an ESD protective material unless the exact product and complete pack have been assessed and specified for that purpose. Paper colour, fibre content or a “natural” appearance does not demonstrate low-charging, dissipative, conductive or shielding properties.

Identify whether the item is ESD-sensitive

Use the manufacturer’s product classification, handling instructions and ESD control program. Bare boards, components and assemblies may have different sensitivity and packaging requirements from a finished consumer device in its retail box.

Do not let warehouse staff make the classification from appearance. If an item or inner pack carries an ESD control marking, route it through the approved process and trained personnel.

Build the specified system from the product outwards

The electrostatic protective package may need low-charging, dissipative, conductive or shielding properties depending on the item and journey. The EOS/ESD Association’s packaging standard overview explains that ANSI/ESD S541 defines packaging properties for ESD-sensitive items during production, transport and storage and references test methods and limits.

Select the bag, tray, box or other protective system through the organisation’s ESD program and ESD coordinator. Bag type matters: an outer material that may be acceptable around one shielding configuration may be unsuitable around another. Close and label the system as specified before it reaches a general shipping carton.

Treat the outer carton as part of the specified packaging system

Do not assume that anything outside a sealed bag is automatically outside the ESD risk assessment. The ESD coordinator must approve the exact device, protective package, outer carton and movement-control configuration. External electric fields, material charging, abrasion and puncture still depend on the whole system.

Where that configuration permits paper, it may fill residual side or top space around the protected unit. It must not puncture, abrade, tear open or force a closure on the electrostatic protective package.

Avoid opening the protective package at a normal packing bench to improve presentation or add an insert. Work inside the relevant electrostatic protected area and follow the handling procedure whenever the barrier must be opened.

Audit the complete pack

Check four separate outcomes:

  • the specified ESD protective package was used and remains closed;
  • the protected unit cannot move or strike the outer carton;
  • no paper edge, accessory or divider threatens the barrier; and
  • labels and traceability remain visible.

For shipment validation, use the test method set by the product, quality and ESD teams. A gentle movement check only screens gross looseness; it does not measure shielding or electrostatic performance.

Train against the common shortcut

The risky shortcut is to wrap a bare board in ordinary paper because it looks soft and recyclable. Replace that judgement with a visual work instruction showing the specified inner package and the point at which the ESD coordinator permits kraft paper void fill within the complete outer pack.

When the specified ESD pack is out of stock or damaged, quarantine the order. Substituting a visually similar bag or adding more void fill is not an equivalent control.

ESD packaging questions

Is kraft paper anti-static?

Do not assume so. Use only packaging materials specified and verified under the organisation’s ESD control requirements.

Can paper touch a sealed ESD bag?

Only when the organisation’s ESD coordinator has accepted the exact outer-pack configuration for that device and protective package. A sealed appearance alone is insufficient.

Does a finished consumer electronic product need the same process as a bare board?

Not necessarily. Follow the manufacturer’s classification and specified packaging for the exact product state.

Tags

Related Articles

© 2026 Cline Plus, Powered by Shopify

    • American Express
    • Apple Pay
    • Google Pay
    • Mastercard
    • PayPal
    • Shop Pay
    • Union Pay
    • Visa

    Login

    Forgot your password?

    Don't have an account yet?
    Create account